Flex FX1471 Manuel De L'utilisateur page 13

To select the "A" mode:
First, check the active mode. Either depress
and release the trigger switch or press the
drive control button or the "A" directly without
Lit indicator displayed
on panel
ON ; OFF
WARNING
running. Sudden change of torque may cause
the loss of control causing possible injury or
damage to the tool or workpiece.
Working
Mode
1
2
3
A
Do not change the working
mode while the tool is
touching the trigger switch. The LED indicator
beside the "A" button will illuminate to indicate
the current mode setting. See more details in
chart below:
Maximum IPM
(Impacts per Application
minute)
Tightening or loosening when you need
1000
fine adjustment with small diameter bolt.
Tightening when you need a precise
1800
control of the tool power.
Tightening when force and speed are
2450
desired.
2450 Loosening with automatic stop.
NOTE: The LED indicator(s) will turn off
approximately 1min after the trigger switch is
released.
NOTE: When the tool is turned on after a break,
the working mode will revert to the last used
setting.
-13-