Charging The Ionboost - Wagan Tech IONBoost V10 Guide D'utilisation

CHARGING THE IONBOOST

This product may arrive partially charged from the manufacturer� It is recommended to
fully charge the unit immediately after purchase and before using for the first time� Prior to
charging the unit, read and understand all instructions in this manual�
In order to prolong the life of the iOnBoost, be sure to fully recharge the unit after each use and
every 3 months even if the iOnBoost has not been used.
WARNING
• Only use the charging adapters supplied with this unit!
• Do not charge the unit on a boat, boat ramp, or dock since the electrical cords and outlets
used for charging could cause severe electrical shock if they get wet.
AC Charging
1. Make sure jumpstarter power switch is in the " " position.
2. Insert AC charging adapter into charge adapter input port.
3. Plug the other end of AC charging adapter into a wall socket. The blue battery status
indicator lights will be illuminated while the unit is charging.
4. Fully charge the unit (average 3-5 hours continuously between uses). Charging is complete
when all battery status indicator lights illuminate solid.
5. When charging is complete, unplug the AC charging adapter from the wall socket first, then
from the charging port on the unit.
6. The battery status can be checked by tapping on the
7. Store the unit and charging adapters in a cool, dry environment, away from flammable
materials. Remember to fully charge the unit every 3 months.
DC Charging in Your Vehicle
Engine must be operating while charging the iOnBoost�
1. Make sure jumpstarter power switch is in the " " position.
2. Turn the vehicle engine on.
3. Insert the DC charging adapter into the charging port of the unit.
4. Plug the other end of DC charging adapter into vehicle's cigarette lighter (DC) or accessory
socket. The blue battery status indicator lights will be illuminated while the unit is charging.
5. Fully charge the unit (around 5-6 hours continuous). Engine must be operating during entire
charge. Charging is complete when all battery status indicator lights illuminate solid.
6. When charging is completed, unplug the DC charging adapter from the vehicle first, then
from the charging port on the unit.
7. The battery status can be checked by tapping on the
8. Store the unit and charging adapters in a cool, dry environment, away from flammable
materials. Remember to fully charge the unit every 3 months.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2015 Wagan Corporation. All Rights Reserved.
button once.
button once.
7