Part 2 - Installer Guide; Installation; Installing The Cooktop - Foster 7371/945 Manuel D'installation Et D'utilisation

PART 2 - Installer Guide

installation

Installing the cooktop

1.
Create the cut-out on the worktop (see chapter ''Worktop cut-out'').
2.
Using 2 or more people, place the cooktop upside down on a covered surface
and predispose sealing material along the whole perimeter of the cooktop.
3.
Place the cooktop centrally in the cut-
out and feed the mains connection cable
down through the cut-out. When doing
this, make sure that the seal under the
cooktop sits flush with the worktop on
all sides. This is important to ensure
an effective seal all round. Do not use
sealant (e.g. silicone). If the seal does
not meet the worktop correctly on the
corners the corner radius can be carefully
scribed to suit.
CAUTION!
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
5/64"
(2mm)
21