SEVERIN BA 3210 Mode D'emploi page 13

∙ Set the temperature control knob to the
required ironing temperature as indicated
by the ironing symbols.
∙ During the heating-up process, the
temperature indicator lamp will be on.
The lamp will go out once the required
temperature is reached. The main
indicator lamp on the handle remains lit
as long as the appliance is connected to
the mains power.
∙ Before ironing any fabric, the soleplate
should be cleaned by passing it over an
old, clean cotton cloth while using the
steam jet function; this helps to fl ush out
any dirt residues or lint particles trapped
inside the openings in the soleplate.
∙ The steam output can be adjusted with
the steam control button, or switched off
completely for dry ironing.
∙ For dry ironing, the water reservoir may
be left empty. But if there is any water
left in the reservoir, the steam jet function
may also be used when dry-ironing at
higher temperature settings.
∙ Place the steam iron upright on its base
stand after use and remove the plug from
the wall socket.
Automatic switch-off
If the appliance is switched on but has not
been used for a certain period of time, it
will automatically switch off. This automatic
switch-off is indicated by a beep signal; in
addition, the main indicator lamp in the
handle fl ashes. The automatic switch-off is
indicated by a beep signal; in addition, the
red indicator light fl ashes. As soon as the
iron is moved, it will switch itself on again.
Horizontal position:
When resting on its sole plate, the iron
will switch off after approx 30 seconds of
inactivity.
Vertical position:
When standing upright on its base, it will
switch off after approx. 8 minutes.
Steam jet
When the steam jet button is depressed, an
additional hot steam jet is emitted from the
soleplate. This function can be very useful
when the normal amount of steam emitted is
not suffi cient to remove stubborn creases, or
when ironing diffi cult or thick fabrics.
For optimum steam output, wait about 4
seconds before using this function again.
The steam jet function may also be used
with the iron held vertically, to remove
creases or wrinkles from fabrics.
Note:
For a more powerful steam jet, set the steam
control to 'dry ironing'.
Using the dual spray nozzle
The laundry can be dampened by pressing
the spray button. This will help to smooth
out diffi cult areas, and may be used at any
temperature during dry or steam ironing.
General care and cleaning
∙ Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
∙ To avoid the risk of electric shock, do not
clean the appliance with water and do not
immerse it in water.
∙ If necessary, the unit may be wiped with a
dry lint-free cloth.
∙ Starch, fat and other deposits on the
soleplate may be removed by wiping with
13