Publicité
Les langues disponibles
Les langues disponibles
deposits in the sole plate.
Filling with water
Fill the water reservoir before using the
steam function or the spray nozzle. Remove
the plug from the wall socket before fi lling
the reservoir.
∙ This iron is to a large extent resistant
to hard water (up to 15º dH). Although
normal tap water may be used, it is
better to use distilled, demineralised or
decalcifi ed water. Should you be unsure
about the hardness of the water in your
area, please enquire of the relevant local
authority department.
∙ Ensure that the steam control button is
closed. It should be opened only once
the temperature level required for steam
ironing [as indicated on the temperature
control knob] has been reached.
∙ Open the cover of the water fi lling hole.
∙ Fill the water reservoir using the
measuring cup provided to the indicated
Max level only.
∙ Close the fi lling hole, ensure that the
cover is heard clicking into place.
Anti-drip function
If the temperature of the soleplate is not
suffi cient to produce steam, the water supply
is cut off automatically to prevent dripping.
General information about ironing
Always check fi rst whether a label with
ironing instructions is attached to the article
to be ironed.
∙ The meaning of the ironing symbols is as
follows:
•
synthetics
(low temperature)
••
silk and wool
12
(medium temperature)
••• cotton and linen
(high temperature)
∙ These markings can also be found on the
temperature control knob of the iron in
form of dot symbols.
∙ Laundry to be ironed should be
sorted according to the fabric ironing
temperature. Follow the ironing symbols
and start with the lowest temperature.
∙ When ironing highly sensitive fabrics, or
if you are not sure about the fabrics, you
can carefully test-iron at a non-visible
point, e.g. the inside of a seam. Start with
the lowest temperature.
∙ If the laundry has been being dried in
a dryer before ironing, the temperature
should be adjusted to 'iron dry'. Very dry
fabrics are diffi cult to iron.
Start up
Clean the iron before using for the fi rst time,
according to the instructions given in the
paragraph 'General Care and Cleaning -
Self-cleaning system'. This will result in
the removal of any dust particles from the
soleplate and subsequently lessen the smell
typically encountered when fi rst switching
on.
Please ensure suffi cient ventilation.
Ironing
∙ Always use the iron on a heat-resistant
surface.
∙ Steam ironing requires high temperatures.
The temperature level for steam ironing
is indicated on the temperature control
knob.
∙ After fi lling the reservoir with water, place
the steam iron upright on its base stand
and insert the plug into the wall socket.
Publicité
