Using The Accessories Supplied; Use; Unwinding The Cable; Switching On And Off - Miele S 4213 Mode D'emploi

en
For hard flooring, such as stone and
parquet, we recommend using one of
the special Miele floor brushes (see
"Optional accessories").
It is important to observe the flooring
manufacturer's cleaning and care
instructions.
Depending on model, the floorhead will
have the following symbols:
– ö and ä
– % and )
Vacuum carpets and rugs with the
brush retracted:
^ Press the ö or % foot control.
Clean hard flooring which is not
susceptible to scratching with the brush
protruding:
^ Press the ä or ) foot control.
Clean flooring which has deep
crevices or grooves with the brush
protruding.

Using the accessories supplied

(dia. 9)
The following accessories are supplied:
a Dusting brush
b Upholstery nozzle
c Crevice nozzle
d Accessories holder for the above
accessories
Symbols on the holder show where
to attach the different accessories.
^ For convenience the accessories
holder can be clipped to the hose
connector (dia. 10).
32
Floorhead (dia. 11)
For general use and also for vacuuming
stairs.
,
Warning: For safety reasons
when vacuuming stairs it is best to
start at the bottom of the stairs and
move upwards.

Use

Unwinding the cable (dia. 12)
^ Pull the mains cable out to the
required length (max. approx. 5.5 m).
^ Insert the plug in the socket correctly
and switch on.
,
Warning: If vacuuming for longer
than 30 minutes, the mains cable
must be pulled out to its fullest
extent. Otherwise there is a danger
of overheating and damage.
Rewinding the cable (dia. 13)
^ Switch the vacuum cleaner off at the
wall socket and unplug it.
^ Press the rewind foot control briefly.
The cable will rewind automatically.
Switching on and off (dia. 14)
^ Press the On/Off foot control s.

Adjusting the suction power

The suction power can be regulated to
suit the type of flooring being cleaned.
Reducing the suction power reduces
the amount of effort required to
manoeuvre the floorhead.