Bartscher 200.264 Mode D'emploi page 29

Setting desired values (required temperature)
To regulate and change desired values:
•
Press
•
increase or lower the value by pressing
•
confirm the new value by pressing
Defrost
Automatic defrost
The device automatically defrosts 3 times per 24 hours. The internal clock is activated the
first time the device is turned on.
If you want to reset the automatic defrost cycle, press and hold
The display will show the symbol
defrost, then the next defrost will begin in 8 hours.
Manual defrost
Manual defrost can be activated at any time in addition to automatic defrost: to do so, press and
hold for over 3 seconds.
Manual defrost will begin, and the display will show the symbol
NOTE!
If you wish to change other settings or parameters, instructions on how to do so
can be found in the information included concerning temperature control, or such
changes can be performed by qualified service personnel.
Tips for the user
•
Place products inside the ventilated saladette after the desired temperature is clearly
visible on the display.
•
Fill appropriate GN containers with ready-to-serve food products, then place the
containers inside the ventilated saladette. Use the GN containers supplied for this
purpose.
•
Do not place warm food products inside the ventilated saladette - they must be
cooled first.
•
Always close and/or pack food products very tightly.
•
During first loading of the ventilated saladette, always open and fill only one shelf at a
time.
- 28 -
for one second
: the set value will begin flashing;
The device will immediately begin automatic
.
or
;
.
for over 3 seconds.
.