EINHELL TH-AC 200/40 OF Mode D'emploi D'origine page 14

Anleitung_TH_AC_200_40_OF_SPK1__ 08.05.13 09:12 Seite 14
GB
We recommend that you clean the appliance
n
immediately after you use it.
Clean the appliance regularly with a damp cloth
n
and some soft soap. Do not use cleaning agents
or solvents; these may be aggressive to the
plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance.
You must disconnect the hose and any spraying
n
tools from the compressor before cleaning. Do
not clean the compressor with water, solvents or
the like.
8.2 Condensation water
The condensation water must be drained off each
day by opening the drain valve (11) (on the floor of
the pressure vessel).
8.3 Safety valve (10)
The safety valve has been set for the highest
permitted pressure of the pressure vessel. It is
prohibited to adjust the safety valve or remove its
seal. Actuate the safety valve from time to time to
ensure that it works when required. Pull the ring with
sufficient force until you can hear the compressed air
being released. Then release the ring again.
8.4 Cleaning the intake filter (12)
The intake filter prevents dust and dirt being drawn
in. It is essential to clean this filter after at least every
300 hours in service. A clogged intake filter will
decrease the compressorʼs performance
dramatically. Remove the filter from the compressor
by unscrewing the screw on the plastic cover (J)
(Figure 6). Lift off the plastic cover (J) and remove
the intake air filter (12) underneath (Figure 7).
Carefully clean the filter by tapping and blowing it
with low pressure compressed air (aprox. 3 bar). To
assemble, proceed in reverse order.
8.5 Storage
I mportant!
Pull the mains plug out of the socket and ventilate
the appliance and all connected pneumatic tools.
Switch off the compressor and make sure that it is
secured in such a way that it cannot be started up
again by any unauthorized person.
Important!
Store the compressor only in a dry location
which is not accessible to unauthorized persons.
Always store upright, never tilted!
14
9. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
n
Article number of the machine
n
Identification number of the machine
n
Replacement part number of the part required
n
For our latest prices and information please go to
www.isc-gmbh.info
10. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.