LENCO CR-630BK Mode D'emploi page 8

Setting the Time/Date
Press and hold Info/Menu button, the <Time/Date> will be shown on screen, press Enter button to
enter time setting mode.
The hour digit will flash. Press the Prev or Next button to set the hour. Press the Enter button to
confirm.
Repeat the last two steps to set the minutes, year, month and date.
System Version
You can check the software version number by pressing and holding the Info/Menu button.Press the
Prev or Next button until <System Version> is shown on the screen, press the Enter button to
confirm.
Resetting the radio
Resetting the radio will delete all the tuned DAB+ stations and all the preset memory stations in FM
and DAB+ modes. To reset the radio:
Press and hold the Info/Menu button.
Press the Prev or Next button until <Factory reset> is shown on screen, press the Enter button and
<Yes> or <No> is shown on the screen. Use Prev or Next button to select <Yes>.
Press the Enter button and radio will be reset.
Sleep setting
Press the Sleep button.
Press the Prev or Next button to select either OFF-120-90-60-45-30-15-5 minutes.
Press the Enter button to confirm.
Using the alarm
Alarm Setting
With radio on, press Alarm button then press Enter button, OFF will flash on display
Then press the Prev or Next button to choose Alarm 1 to ON position, press Enter button to confirm.
The hours will flash, use the Prev or Next button to select hour. Press Enter button to confirm.
The mins will flash; use the Prev or Next button to select the minutes. Press Enter button to confirm.
The Vol digit will flash, use the Prev or Next button select the Volume. Press Enter button to confirm.
The Alarm source will flash, use the Prev or Next button select the Alarm source: Alarm/DAB/FM.
Press Enter button to confirm.
With radio on, press Alarm button twice to set Alarm 2:
The setting procedure is the same as the "ALARM1".
NOTE: You can press the Info/Menu button to get back last one step when in the process of the
setting the alarm.
8