Güde GGH 35 TRI Mode D'emploi Original page 13

The gas heater must not be used:
•
For heating of closed or residential spaces
(residential buildings) or operation in such
spaces;
• Close to flammable materials (e.g. paper,
construction materials);
• On places where volatile materials are
stored/present (e.g. gasoline, solvents,
chemicals) or where explosive atmosphere may
be generated;
• Following unauthorized structural change to the
gas heater;
• In case of incorrect or unacceptable connection
to gas source;
• On places insufficiently ventilated;
•
As source of heating during social events and
family celebrations.
Instructions for installation and putting the appliance
into operation (pic. B-K)
Appliance to be used on a level, stable and non-
flammable surface. Never use the appliance near open
fire or flying sparks or similar high-flammable
substances!
1. The appliance may only be used with propane or butane.
2. Connect the gas hot air turbine as specified in pic. B-F.
3. All connectors to be checked for gas detection using lye
soap or leak detection spray. (pic. F+G)
4. Plug the appliance (pic. G)
5. Position "I". The gas hot air turbine only runs with the fan
function and provides air circulation in the room. (pic. I)
6. Position "II". The gas hot air turbine is now also heating
(pic. J). However, the appliance is only started when the
required temperature (pic. K/12) is set higher than the
actual temperature (pic. K/11) (room temperature).
7. Electronic control: Pic. K/11 shows the room
temperature. Use the thermostat (pic. K/8) to control/set
the required temperature – see the indicator (pic. K/12).
(The gas hot air turbine is automatically switched on and
then switched off when the required temperature is
reached).
Example of use:
"II" (pic. J) 15°C actual temperature (pic. K/11)
20° temperature required (pic. K/12).
The gas hot air turbine is now able to heat the "space"
to 20°C and then is automatically switched off. If the
appliance remains in the emergency position, the gas
hot air turbine is automatically switched on when it is
below the required temperature.
8. If the controller (pic. K/8) is set below the actual room
temperature shown on the digital indicator (K11), the
appliance also gets switched off.
Example of use:
18°C actual temperature (pic. K/11)
temperature required (pic. K/12).
turbine now gets switched off. If the appliance remains in
the emergency position, the gas hot air turbine is
automatically switched on when it is below 15°C.
The indicator (K/4) lights up in case of failure or when the
gas bottle is empty.
Press Reset (pic. K/6) and put ON/OFF to "0" or change
the gas bottle and connect it as specified in pic. B+F. The
gas hot air turbine can now be switched on again as
specified.
Switching off (pic. L-M))
To switch the gas hot air turbine off, close the gas bottle
valve (pic. L) first at all times.
Switch the appliance off by ON/OFF (pic. M). To the
position "0".
15°C
The gas hot air
To unplug the appliance, disconnect the plug (pic. M).
Changing the gas bottle
•
When outdoors and in a safe distance from any fire or
flammable sources and with no persons around
proceed as follows!
• Close the gas bottle valve. (E/1)
•
Unscrew the pressure reducing valve (pic. B-D in the
reverse order).
•
Make sure pressure reducing valve gasket is in place.
• Connect the appliance to a new gas bottle and
proceed as specified in pic. B-H).
Transport, storing and cleaning
The appliance may only be carried using the carrying
handle.
Appliances not being used must be kept in a dry
and locked room.
• To clean the appliance, use a smooth and fine soap
water solution. Prevent any direct contact of
aggressive cleaning agents with the appliance. No
aggressive, volatile or caustic cleaning agents may be
used.
•
Have the gas hot air turbine checked by a qualified
authorised expert once a year.
•
The hose must necessarily be replaced if
damaged.
•
The appliance needs to be protected against moisture
and dust.
•
If the appliance has not been used for a long time,
disconnect it from the gas bottle and keep it covered in
a dry and safe place inaccessible to children.
Service
Any technical questions? Complaint? Do you need
spare parts or operation manual?
Go to our website www.guede.com and the section
Service will help you quickly and without bureaucracy.
Please, help us to help you. In order to identify your device
in case of complaint, please indicate serial number, order
number and year of manufacture. All information is
available on the product label. To have all information
always at hand, put them down.
Serial number:
Order number:
Year of manufacture:
Phone: +49 (0) 79 04 / 700-360
Fax: +49 (0) 79 04 / 700-51999
E-Mail: support@ts.guede.com