Publicité
Les langues disponibles
Les langues disponibles
•
Disconnect the appliance from the mains
supply.
•
Cut off the mains electrical cable close to the
appliance and dispose of it.
INSTALLATION
WARNING! Refer to Safety chapters.
BEFORE THE INSTALLATION
Before you install the hob, write down the
information bellow from the rating plate. The rating
plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
GAS CONNECTION
WARNING! The following instructions
about installation, connection and
maintenance must be carried out by
qualified personnel in compliance with
standards and local regulations in
force.
It is necessary that the connection to the gas mains
are carried out by means of an AGB tap. Choose
fixed connections or use a flexible pipe in AGB
(stainless steel) in compliance with the regulation in
force (NBN D 51.003). If you use flexible metallic
pipes, be careful they do not come in touch with
mobile parts or they are not squeezed. Also be
careful when the hob is put together with an oven.
Make sure that the gas supply
pressure of the appliance obeys the
recommended values. The adjustable
connection is fixed to the
comprehensive ramp by means of a
threaded nut R 1/2". All the
components shown in the figure have
already been assembled in the factory.
The appliance, before leaving the
factory, has been tested in order to
give you the best results.
•
Flat the external gas pipes.
A
B C
A. End of shaft with nut
B. Washer supplied with the appliance
C. Elbow supplied with the appliance
Liquid gas
Use the rubber pipe holder for liquid gas. Always
engage the gasket. Then continue with the gas
connection.
The flexible pipe is prepared for apply when:
•
it can not get hot more than room temperature,
higher than 30°C;
•
it is no longer than 1500 mm;
•
it shows no throttles;
•
it is not subject to traction or torsion;
•
it does not get in touch with cutting edges or
corners;
•
it can be easily examined in order to make sure
its condition.
The control of preservation of the flexible pipe
consists in checking that:
•
it does not show cracks, cuts, marks of burnings
on the two ends and on its full length;
•
the material is not hardened, but shows its
correct elasticity;
•
the fastening clamps are not rusted;
•
expired term is not due.
If one or more defects are visible, do not repair the
pipe, but replace it.
WARNING! When installation is
complete, make sure that the seal of
each pipe fitting is correct. Use a
soapy solution, not a flame!
INJECTORS REPLACEMENT (ONLY FOR
BELGIUM)
1. Remove the pan supports.
2. Remove the caps and crowns of the burner.
21
Publicité
