Publicité
Les langues disponibles
Les langues disponibles
SAFETY INSTRUCTIONS
This appliance is suitable for the following markets:
BE LU
INSTALLATION
WARNING! Only a qualified person
must install this appliance.
WARNING! Risk of injury or damage
to the appliance.
•
Remove all the packaging.
•
Do not install or use a damaged appliance.
•
Follow the installation instructions supplied with
the appliance.
•
Keep the minimum distance from other
appliances and units.
•
Always take care when moving the appliance as
it is heavy. Always use safety gloves and
enclosed footwear.
•
Seal the cut surfaces with a sealant to prevent
moisture to cause swelling.
•
Protect the bottom of the appliance from steam
and moisture.
•
Do not install the appliance adjacent to a door
or under a window. This prevents hot cookware
falling from the appliance when the door or the
window is opened.
•
If the appliance is installed above drawers make
sure that the space, between the bottom of the
appliance and the upper drawer, is sufficient for
air circulation.
•
The bottom of the appliance can get hot. Make
sure to install a non-combustible separation
panel under the appliance to prevent access to
the bottom.
ELECTRICAL CONNECTION
WARNING! Risk of fire and electric
shock.
•
All electrical connections should be made by a
qualified electrician.
•
The appliance must be earthed.
•
Before carrying out any operation make sure
that the appliance is disconnected from the
power supply.
•
Make sure that the parameters on the rating
plate are compatible with the electrical ratings
of the mains power supply.
•
Make sure the appliance is installed correctly.
Loose and incorrect electricity mains cable or
plug (if applicable) can make the terminal
become too hot.
•
Use the correct electricity mains cable.
•
Do not let the electricity mains cable tangle.
•
Make sure that a shock protection is installed.
•
Use the strain relief clamp on the cable.
•
Make sure the mains cable or plug (if
applicable) does not touch the hot appliance or
hot cookware, when you connect the appliance
to the near sockets.
•
Do not use multi-plug adapters and extension
cables.
•
Make sure not to cause damage to the mains
plug (if applicable) or to the mains cable.
Contact our Authorised Service Centre or an
electrician to change a damaged mains cable.
•
The shock protection of live and insulated parts
must be fastened in such a way that it cannot be
removed without tools.
•
Connect the mains plug to the mains socket
only at the end of the installation. Make sure that
there is access to the mains plug after the
installation.
•
If the mains socket is loose, do not connect the
mains plug.
•
Do not pull the mains cable to disconnect the
appliance. Always pull the mains plug.
•
Use only correct isolation devices: line
protecting cut-outs, fuses (screw type fuses
removed from the holder), earth leakage trips
and contactors.
•
The electrical installation must have an isolation
device which lets you disconnect the appliance
from the mains at all poles. The isolation device
must have a contact opening width of minimum
3 mm.
GAS CONNECTION
•
All gas connections should be made by a
qualified person.
•
Before installation, make sure that the local
distribution conditions (nature of the gas and
gas pressure) and the adjustment of the
appliance are compatible.
•
Make sure that there is air circulation around the
appliance.
•
The information about the gas supply is on the
rating plate.
•
This appliance is not connected to a device,
which evacuates the products of combustion.
Make sure to connect the appliance according
to current installation regulations. Pay attention
to requirements regarding adequate ventilation.
19
Publicité
