Operating Determinations; Connections; Mains Input - EuroLite CH-4 Mode D'emploi

Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a strobe-controller for controlling strobes in discotheques, on stages etc This product is
allowed to be operated with an alternating current of 220-250 V AC, 50 Hz ~ and was designed for indoor
use only.
Never put any liquids close to the device. Should any liquid enter the device nevertheless, disconnect from
mains immediately. Please let the device be checked by a qualified service technician before you operate it
again. Any damages caused by liquids having entered the device are not subject to warranty!
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks. When using smoke machines, make sure that the device is never exposed to the direct smoke jet
and is installed in a distance of 0.5 meters between smoke machine and device. The room must only be
saturated with an amount of smoke that the visibility will always be more than 10 meters.
The ambient temperature must always be between -5° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
Please use the original packaging if the device is to be transported.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, etc.

CONNECTIONS

Mains input

Connect the 3-core lead (3 x 1.5 mm²) to the mains supply.
Plug the power-plug into your safety socket.
Brown
Blue
Green/Yellow
The STROBE CONTROLLER CH-4 must be earthed.
live
neutral
earth
11/22 52202214_V_1_0.DOC