Makita LS1013 Manuel D'instructions page 15

Table (B)
Molding
Molding edge against
position in
Fig. A
Wall contact edge should be
(1)
against guide fence.
For inside
corner
(2)
Ceiling contact edge should
be against guide fence.
(3)
For
outside
Wall contact edge should be
corner
(4)
against guide fence.
Example:
In the case of cutting 52/38° type crown
molding for position (1) in Fig. A:
• Tilt and secure bevel angle setting to
33.9° RIGHT.
• Adjust and secure miter angle setting to
31.6° RIGHT.
• Lay crown molding with its broad back
(hidden) surface down on the turn base
with its WALL CONTACT EDGE against
the guide fence on the saw.
• The finished piece to be used will
always be on the RIGHT side of the
blade after the cut has been made.
Finished piece
guide fence
Finished piece
will be on the
Right side of
blade.
Finished piece
will be on the
Left side of
blade.
006364
15