Makita DUC204 Manuel D'instruction page 18

1
2
► 1. File 2. Saw chain
— The file can be guided more easily if a file
holder (optional accessory) is employed. The
file holder has markings for the correct sharp-
ening angle of 30° (align the markings parallel
to the saw chain) and limits the depth of pene-
tration (to 4/5 of the file diameter).
30
► 1. File holder
— After sharpening the chain, check the height
of the depth gauge using the chain gauge
tool (optional accessory).
— Remove any projecting material, how-
ever small, with a special flat file (optional
accessory).
— Round off the front of the depth gauge
again.
1
1/5
Cleaning the guide bar
Chips and sawdust will build up in the guide bar
groove. They may clog the bar groove and impair
the oil flow. Clean out the chips and sawdust
every time when you sharpen or replace the saw
chain.
Cleaning the sprocket cover
Chips and saw dust will accumulate inside of the
sprocket cover. Remove the sprocket cover and
saw chain from the tool then clean the chips and
saw dust.
Cleaning the oil discharge hole
Small dust or particles may be built up in the oil
discharge hole during operation. These dust or
particles may impair the oil to flow and cause an
insufficient lubrication on the whole saw chain.
When a poor chain oil delivery occurs at the
top of guide bar, clean the oil discharge hole as
follows.
1. Remove the sprocket cover and saw chain
from the tool.
18 ENGLISH