RIDGID HD06001 Mode D'emploi page 7

ASSEMBLY
Carry Handle Assembly
1. Locate the Carry Handle and the two
(2) #10 x 3/4" Pan Head Screws in
loose parts bag.
2. Position the Carry Handle on top of the
Powerhead Assembly, with the Carry
Handle Extended Flange to the rear of
the Powerhead, as shown.
3. Insert a #10 x 3/4" Pan Head Screw
through the hole at each end of the
Carry Handle and into the Powerhead
Assembly. Tighten securely.
Extended
Flange
SP7072 HD06001 HD09001 ESF_HD06001 HD09001.indd 7
#10 x 3/4" Pan
Head Screws (2)
Carry Handle
Powerhead
Assembly
7
Inserting the Tug-A-Long
Positive Locking Hose with
Dual-Flex
1. Insert the larger end of the Tug-A-
Long Positive Locking Hose with
Dual-Flex into the Inlet Port. Engage the
Hose Latch to the lip of the Inlet Port.
The Hose should snap into place.
2. To remove the Tug-A-Long Positive
Locking Hose with Dual-Flex from the
Vac, press the Release Button on the
Hose and pull the Hose out of the Inlet
Port, as shown.
Tug-A-Long Positive
Locking Hose with
Dual-Flex
Powerhead
Assembly
Vac Inlet
Release
Button
7/10/18 2:07 PM