Yamaha YFM250XR Manuel Du Propriétaire page 82

1. Light switch "LIGHTS"
2. Engine stop switch "ENG. STOP"
3. Start switch "START"
4. Horn switch " "
1. Contacteur d'éclairage "LIGHTS"
2. Coupe-circuit du moteur "ENG. STOP"
3. Contacteur du démarreur "START"
4. Contacteur de l'avertisseur "
1. Interruptor de luces "LIGHTS"
2. Interruptor de paro del motor "ENG. STOP"
3. Interruptor de arranque "START"
4. Interruptor de la bocina "
"
"
NOTE:
If the starter switch is pushed with the main switch
"ON" and the engine stop switch "OFF", the starter
motor will be activated but the engine will not start.
To start the engine, be sure to position the engine
stop switch at "RUN".
Light switch "LIGHTS"
Turn the switch to the "LO" position to switch on
the low beam and the tail/brake light.
Turn the switch to the "HI" position to switch on the
high beam and the tail/brake light.
Turn the switch to the "OFF" position to switch off
the headlights and the tail/brake light.
CAUTION:
Do not use the headlights with the engine
turned off for more than thirty minutes. The
battery may discharge to the point that the
starter motor will not operate properly. If this
should happen, remove the battery and re-
charge it.
4-7
EBU01076