Operation; Cleaning Your Appliance; Maintenance - Impecca RA-2138 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION

TEMPERATURE CONTROL OPERATION
The temperature in the refrigerator compartment is controlled by the temperature controller
installed on the fridge air column. Turn the thermostat knob to regulate the temperature inside
the refrigerator. The marks on the knob do not represent the temperature in degrees, but the
temperature grades from "1" to "7". The first grade corresponds to the highest temperature and
the 7th grade corresponds to the lowest temperature the refrigerator can produce. Turn the knob
from position "1" to position "7", the temperature decreases continuously. Set the thermostat
knob to position "3-4" for a normal use.
FREEZER TEMPERATURE CONTROL
The temperature in the freezer compartment is controlled by the temperature controller installed on the back wall of freezer com-
partment. Slide the regulation element to regulate the temperature inside the freezer Slide the regulation element from "MIN" posi-
tion to "MAX" position, the temperature decreases continuously.

CLEANING YOUR APPLIANCE

Remove all the shelves and the salad bin. To remove the salad bin first remove the lower shelf.
Wipe the inside of the unit with a weak solution of bicarbonate soda and then rinse with warm water using a "wrung-out" sponge or
cloth. Wipe completely dry before replacing the shelves and salad bin.
Use a damp cloth to clean the exterior, and then wipe with a standard general purpose cleanser. Make sure that the door is closed
to avoid the cleanser from getting on the magnetic door seal or inside the unit.
Condensation may appear on the outside of the unit. This may be due to a change in room temperature. Wipe off any moisture
residue. If the problem continues, please contact a qualified technician for assistance.

MAINTENANCE

CHANGING THE INTERNAL LIGHT
This unit uses a MAX 10W lamp located at the top of the compartment near the opening.
Note: Light bulb may be extremely hot.
1.
Unplug the refrigerator
2.
Locate and remove the faulty light bulb
3.
Replace with an appliance bulb of the same or lower
wattage.
4.
Plug the refrigerator back in.
MOVING YOUR UNIT
Hold the unit around its sides or base when moving it. Under no circumstances should it be lifted by holding the edges of the top
surface.
SERVICING
The unit should only be serviced by an authorized technician and only genuine spare parts should be used. Repairs carried out by
inexperienced persons may cause injury or serious malfunction.
SWITCHING ON AND OFF FOR LONG PERIODS OF TIME
When the unit is not in use for a long period of time, disconnect it from the main power supply, empty all food and clean the appli-
ance. Leave the door ajar to prevent unpleasant smells.
–8–

Publicité

Table des Matières
loading

Table des Matières