Accessories - WOLFF MAMBO 230 V Mode D'emploi

Speed control
Adjust the speed of the discs with switch (4). Turning clock-wise
increases the speed, turning anti-clock-wise decreases the
speed. The optimal speed is dependent on the disc used and the
subfloor.
The table below It is meant as guiding principle for the user.
Always test the optimum speed in each case. Always start at
low speed and then increase the speed.
Speed Use
160-200 Grinding screed and
levelling compounds
200-300 grinding parquet
removing levelling compounds
and adhesive residues
300-400 Polishing resilient flooring
Removing the sealing of
resilient floors
removing levelling compounds
400-450 Hard grinding and milling works
Multi-Speed polishing of
resilient floors
Always remove discs or brushes after work.
Remove also the cleaning tank, if one has been used. Always
disconnect the power cord after work or when leaving the machine.
Transportation
For transportation fold the handle forwards. For carrying the
machine, use the recessed grips at the front and at the back.
6.0 Accessories for the grinding machine
6.1 Vacuum unit
The vacuum unit Micropac or an external industrial vacuum
cleaner may be used.
Mounting the vac Micropac (Item-No. 013496)
Assemble the vacuum unit from the front of the handle of the
machine.
insert vac into the lower support
turn vac at the top against the handle and fasten the thumb
screws
fasten hose to the vac by turning clockwise
attach hose to the outlet spigot of the machine
09/2004 Schleifmaschine MAMBO, Artikel-Nr. 013495, ab 324 vom
Recommended disc
Grinding paper, grinding
gauze
Grinding gauze
Carbide grinding disc and
System- milling disc
Pads
Scrubbing brush
System- milling disc
System-milling disc
Pads
21-09-04Fugenfräse FRÄSMASTER
(4)
The speed for finish grinding on levelling compounds
should not be higher than 200 r.p.m. Otherwise the
adherence of adhesives may be severely reduced.
15