Trouble Shooting - WOLFF MAMBO 230 V Mode D'emploi

System carbide milling wheel disc with 4 modules, Item-No. 013569:
for removing adhesives, PU- and epoxy-coatings and roughening anhydrite pavements („beating" action).
Due to the aggressive action, the system milling disc should not be used onto chip board.
Milling disc with star wheel segments Item-No. 016149
Additional to the new System-milling-disc the milling disc with star wheel segments offers high efficiency.
Producing a high effect of dismounting and an aggressive action, this disc is used for removing coatings and
adhesive residues. The result is a rough surface. Comes with 3 star wheel segments.
Cleaning pad discs 400mm, 10mm
For initial cleaning, Item-No. 013543, For cleaning and mounting of gauze
For maintenance, Item-No. 013544, For coarse cleaning and removing soil
For polishing, Item-No. 013545, For polishing, cleaning and wax coating
Super pad discs 400mm, 20mm
For initial cleaning, Item-No. 013546, For cleaning strong soiling
For maintenance, Item-No. 013547, For coarse cleaning and removing soil
For polishing, Item-No. 013334, For polishing, cleaning and wax coating

8.0 Trouble shooting

Trouble
Machine does not
start
Switch-on lever
cannot be actuated
09/2004 Schleifmaschine MAMBO, Artikel-Nr. 013495, ab 324 vom
Eventual cause
Power supply
Disconnected
blown fuse
defective cable or plug
Safety lever can only be
actuated, if handle not vertical
21-09-04Fugenfräse FRÄSMASTER
Elimination
Have machine
repaired by a qualified
electrician,
resp. change parts
Lower the handle of
the machine
19