Attaching The Network Cable; Aligning The Camera; Zoom And Focus Settings - Abus IPCA22500 Manuel Utilisateur

6.4 Attaching the network cable

The maximum network cable (CAT7) length from the camera to the nearest active network point
(e.g. network switch) should not exceed 100 metres.

6.5 Aligning the camera

Instructions for how to align the camera are given in the quickstart guide for the relevant IP
camera IPCAXXXX.

6.6 Zoom and focus settings

IPCA22500 / IPCA32500 / IPCA62500 / IPCA62505 / IPCA72500 / IPCA72505
The cameras have a built-in Motor Vario zoom lens. It is possible to change the zoom factor or
adapt the focus via the camera's web interface ("installer" access).
The zoom factor can be changed in stages, whereas the focus is automatically set for each of
these zoom factors. It's possible to change the focus of each zoom factor via the camera's web
interface ("installer" access). The change will be saved to the camera (over button "SAVE" on
main page of "installer" access).
The IPCA72505 has separate focus settings for day and night mode.
By default automatic focusing is carried out in the day mode as well as in the night
mode. If this fails due to the scene scene (for example, by objects in the field of view
in the near and far range), the desired focus can be manually set and stored using
the buttons on the LIVE page.
The stored value is then used for the next day or night switching.
When the camera undergoes a factory reset, the factory-set zoom/focus relationship is reset too.
IPCA52000
Settings for zoom and focus are made manually in the lens to be installed (lens is not included in
the scope of delivery).
72