Publicité
Les langues disponibles
Les langues disponibles
Remove the Monoblock recirculation filter
The Monoblock filter is located on the top of the hood.
The grille on top of the hood can be opened by pulling it
towards the wall. The Monoblock filter is located in the
cutout and you can remove it from there.
Regenerate the Monoblock recirculation filter
• The Monoblock can be regenerated up to 12 times.
This is done in the oven.
• • Place the filter in the oven for 1 hour at 120°C. Pro-
vide sufficient fresh air in the room where the oven
has been placed, as smells can be released. Smells
can be released when baking certain kinds of fish.
In this case it is best to immediately regenerate the
filter in the oven.
Reset the Monoblock recirculation filter
The cooker hood (motor) must be running
Simultaneously press [+] and [–] for 5 sec. until the red
indicator lamp flashes 3 times for confirmation. If the
programming is not carried out, the programming is
automatically set after the chimney hood has been
switched on 10 times.
After a reset, the cleaning indication will be set to 200
hours.
Place the Monoblock recirculation filter
Replace the Monoblock filter at the top of the hood and
close the grille.
Programming en deactivate the recirculation pro-
gram
• The motor must be switched off.
• Simultaneously press the [+] and the [–] keys on the
hood for 5 seconds until the third green LED flashes
3 times.
4.3 Maintenance of the hood
Please allow the lights to cool down sufficiently before
cleaning the hood. Use a soft, wet cloth and a mild
detergent to clean the hood.
Never use aggressive, abrasive detergents or sponges.
Bleach will damage stainless steel.
The stainless steel surfaces can be treated with Novy
Inoxcleaner (906.060) after cleaning.
4.4 Led lighting
Replacing the led lighting
First, remove the power supply from the hood and
allow the lighting to cool down sufficiently.
Open the glass plate and remove the grease filters from
the hood. You can reach the 2 LED spotlights at the
bottom of the hood with your hand.
Removing the LED lamp
First disconnect the cable to the LED to be replaced.
Disconnect by means of releasing the lock, by applying
light pressure while at the same time pulling away.
Next, remove the LED to be replaced by making a gen-
tle rotating movement to the left.
Mounting the new LED
Place the new LED light into the locking ring.
Make a rotating movement to the right until the LED
light is locked. Connect the power cable.
4.5 Technical problem
In case of technical problems please contact Novy
Service Department:
• For Belgium: Tel.: 056/36.51.02
• For France: Tel.: 03.20.94.06.62
• For Germany: Tel.: 0511.54.20.771
For all other countries: your local installor or Novy Bel-
gium: +32 (0)56/36.51.02
Please supply us with the model number of your hood.
The model number can be found on the engra-
ved plaque behind the filter.
You can make a note of the number here:
.................................
Dimensions: p. 14-15
Electrical scheme: p. 16
EN 16
Publicité
