Wolf ICBMW30-230 Guide D'utilisation Et D'entretien page 17

W O L F C O N V E C T I O N M I C R O W A V E
I N S TA L L I N G T H E M I C R O W A V E
1) Remove all packaging and check carefully
for any signs of damage.
2) If the microwave is fitted in position C,
ensure that the minimum air gaps are main-
tained as shown in the diagram.
3) Secure four cupboard retention blocks in
position using the setting template
(TMAPTA004URR0).
4) Fit the appliance into the kitchen cupboard,
lift over the bottom/front blocks then push
slowly, and without force, until the front
frame of the oven seals against the front
opening of the cupboard.
5) Ensure the appliance is stable and not
leaning.
6) Fix the oven in position with the screws
provided. The fixing points are located
within the louvre areas at the top and
bottom of the oven (see illustration on
page 12).
7) Fit the frame fastner caps to the four fixing
positions (2 spare caps are provided).
8) It is important to ensure that the installation
of this product conforms to the instructions
in this operation manual and the conven-
tional oven or hob manufacturer's installa-
tion instructions.
Chimney
Cable clip
Position A
Conventional
oven
The microwave can be fitted in position A, B or C
I N S TA L L AT I O N
Position C
Position A
Conventional
oven
Niche Size
Position W x D x H
A 730 x 610 x 450
B 730 x 610 x 450
C 730 x 610 x 450
Measurements in millimeters
Chimney
Cable clip
Position B
D
Position B
65 mm
Position C
Chimney Gap Between
(min) Cupboard & Ceiling
20 50
20 50
20 Not Applicable
17