Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
20 lb LP Gas Models
Tools Needed
■
Tape measure
■
Small, flat-blade screwdriver
■
Flat-blade screwdriver
■
#2 and #3 Phillips screwdriver
■
Level
Parts Supplied
■
Gas pressure regulator/hose assembly set for 11" WCP LP
gas (attached to manifold).
■
Rotisserie motor mounting bracket
■
Rotisserie motor
■
Rotisserie forks
■
Rotisserie spit
■
Smoker box
■
1 single-prong plug/500 mAmp transformer assembly for the
rotisserie motor
■
1 single-prong plug/5,000 mAmp transformer assembly for
the grill (power supply)
■
Convertible regulator set for 4" WCP Natural gas
■
Conversion kit for Natural gas
■
LP gas fuel tank tray
■
1.5 V "D" size alkaline batteries
■
Vinyl grill cover
Parts Needed - 20 lb LP gas models
■
20 lb LP gas fuel tank - approximately 18" (45.7 cm) height
and 12" (30.5 cm) diameter
INSTALLATION REQUIREMENTS
Tools and Parts
■
Wrench or pliers
■
Pipe wrench
■
Scissors or cutting pliers
(to remove tiedowns)
■
Noncorrosive leak-
detection solution
Natural Gas Models
Tools Needed
■
Tape measure
■
Small, flat-blade screwdriver
■
Flat-blade screwdriver
■
#2 and #3 Phillips screwdriver
■
Level
Parts Supplied
■
Convertible regulator set for 4" WCP Natural gas
■
1 single-prong plug/500 mAmp transformer assembly for the
rotisserie motor (on some models)
■
1 single-prong plug/5000 mAmp transformer assembly for
the grill (power supply)
■
1.5-volt "D" size alkaline battery (on some models)
■
Rotisserie motor mounting bracket (on some models)
■
Rotisserie motor (on some models)
■
Rotisserie forks (on some models)
■
Rotisserie spit (on some models)
■
Smoker box (on some models)
Parts Needed
■
Gas line shutoff valve
■
½" male pipe thread nipple for connection to pressure
regulator
■
LP gas-resistant pipe-joint compound
■
CSA design-certified outdoor flexible stainless steel
appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply
line as needed
■
Wrench or pliers
■
Pipe wrench
■
Scissors or cutting pliers
(to remove tiedowns)
■
Noncorrosive leak-
detection solution
5