Ryobi P542 Manuel D'utilisation page 15

WARNING:
Do not cut trees or branches near buildings,
which may result in serious injuries or property
damage.
WARNING:
Check the tree for damaged or dead branches
that could fall and hit you during felling.
WARNING:
Periodically glance at the top of the tree during
the backcut to assure the tree is going to fall in
the desired direction.
WARNING:
If the tree starts to fall in the wrong direction,
or if the saw gets caught or hung up during the
fall, leave the saw and save yourself!
 Felling a tree - When bucking and felling opera-
tions are being performed by two or more per-
sons, at the same time, the felling operation
should be separated from the bucking operation
by a distance of at least twice the height of the
tree being felled. Trees should not be felled in a
manner that would endanger any person, strike
any utility line or cause any property damage. If
the tree does make contact with any utility line, the
utility company should be notified immediately.
 Before any cuts are started, pick your escape
route (or routes in case the intended route is
blocked); clear the immediate area around the
tree and make sure there are no obstructions
in your planned path of retreat. Clear path of
safe retreat approximately 135° from planned
line of fall. The retreat path should extend back
and diagonally to the rear of the expected line
of fall. See Figure 12.
 Before felling is started, consider the force and
direction of the wind, the lean and balance of
the tree, and the location of large limbs. These
things influence the direction in which the tree
will fall. Do not try to fell a tree along a line dif-
ferent from its natural line of fall.
OPERATION
 The chain saw operator should keep on the
uphill side of the terrain as the tree is likely to
roll or slide downhill after it is felled.
 Remove dirt, stones, loose bark, nails, staples,
and wire from the tree where felling cuts are to
be made.
 Notched Undercut. Cut a notch about 1/3 the
diameter of the tree, perpendicular to the direc-
tion of fall. Make the cuts of the notch so they
intersect at a right angle to the line of fall. This
notch should be cleaned out to leave a straight
line. To keep the weight of the wood off the saw,
always make the lower cut of the notch before
the upper cut. See Figure 13.
PLANNED LINE OF FALL
PLANNED PATH OF SAFE RETREAT 135° FROM PLANNED
PLANNED
LINE OF FALL
BACK CUT
2 in.
15 - English
90°
LINE OF FALL
SAFE
RETREAT
ZONE
135°
45°
90°
45°
135°
SAFE
RETREAT
ZONE
HINGE
2 in. OR 1/10 DIA
NOTCH -
APPROX. 1/3
DIAMETER OF
TRUNK
SAFE
RETREAT
ZONE
Fig. 12
Fig. 13