VINCENT PHO-200 Manuel D'utilisation page 27

3. Switching between
MM and MC:
push all DIL switches at the
underside of the PHO-200 to
the right in order to adapt to
moving-magnet cartridges and
accordingly to the left to adapt
to moving-coil cartridges.
4. IN: signal input from
the record player
The audio output (or as well an
attached audio cable) of the
record player must be connec-
ted to these input sockets.
5. OUT: signal output
to the amplifier
A pair of RCA input sockets of
your system's audio amplifier
must be connected with these
output sockets.
6. GND: Ground clamp for
the record player
In addition to the stereo signal
connection cable most record
players are equipped with a
grounding cable that can be
recognized by the cable lug at
the end of the cable. This lug
has to be fitted to the clamp
"GND".
7. 12-16V AC: power supply
input of the PHO-200
Plug in the power connector at
the end of the cable (8) of the
supplied AC
Connect the AC adaptor to the
mains voltage. Always connect
the AC adaptor to the mains
before you switch on the ampli-
fier/preamplifier!
8. Power supply with power
plug
This power supply adaptor is
supplied with the PHO-200 and
converts the mains voltage to a
more suitable supply voltage.
After you made the connection
to the PHO-200, plug it into a
mains socket as the last step of
the Installation.
9. Power Supply Cable
Make a connection to the PHO-
200 back plate power socket
(7).
adaptor (7).
Vincent
27