Change The Batteries; Faults - Novy Mini Pure'line 810 Mode D'emploi

3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the LED
light is locked.
C. Connect the power cable.
D. Place the spotlight holder back in the cooker hood and
reconnect the power.
Change in colour temperature with LED-lighting
First make sure that the power supply of the hood has
been disconnected. Remove the plug from the hood or
switch off the power group.
The colour of the LED-lighting has been set to 2.700 K
(warm white) by default. If the colour is to be changed to
4.000 K (neutral white), follow the instruction given below:
− Open the bottom panel at the bottom of the hood.
− Press with two hands against the side of the inox lamp
holder and carefully pull down simultaneously, so you
get access to the lighting on the inside.
− The wiring has been connected to the LED-lamp with
a connector.
− Disconnect the connector from the LED-lamp and move
the wiring to the other free connection on the lamp.
− Repeat this for all four LED-lamps.
− Then close the inox lamp holder again.
The colour of the LED-lighting has now been changed
from 2.700 K to 4.000 K.

3.6 Change the batteries

− For changing the batteries unscrew the plastic cover,
remove the old batteries and insert the new ones. Pay
attention to the polarity marking given in the battery
compartment.
− Empty batteries are not to be disposed of in the household
refuse, but they are to be handed in as chemical waste.
Technical information
− Power supply: 2xAAA batteries
− Frequence: 433.92Mhz
− Numbre of codes: 10
− Worktemperature: 0-50°C
− Dimensions: 110 x 50 x 19mm

3.7 Faults

If there is a fault you can contact your (kitchen) supplier
and/or Novy Customer Service.
Belgium Tel.: +32 (0)56 36 51 02
France Tel.: +33 (0)3 20 94 06 62
Germany Tel.: +49 (0)511 54 20 771
The Netherlands Tel.: +31 (0)88 011 91 10
United Kingdom Tel.: +44 (0) 207 866 2493
Italy Tel.: +39 (0)39.20.57.501
For all other countries: your local installer or
Novy in Belgium: +32 (0)56 36 51 02
To be able to deal with the fault promptly and efficiently it
is necessary that the Repaired Service knows which type
of appliance you have.

You can find the type number on a sticker in
the inside of the extractor hood. This becomes
visible as soon as you take the filter out of the
extractor hood.
You can note the type number here:
– 40 –