HQ Power HQSM10005 Mode D'emploi page 8

7.3 Detailed Operation
Control Panel Description
MENU scroll through the menu options
ENTER confirm a selection
UP upwards through the menu list
DOWN downwards through the menu list
Menu
display description
Addr set the DMX address from 1 to 512
rEno turn the remote control on or off
OrL turn the fluid sensor on or off
DMX Configuration
To set the smoke machine in DMX mode:
1. Connect the smoke machine to the mains, switch it on and let it warm up.
2. Connect a DMX cable to the DMX input of the haze machine and the DMX output of a controller (not
included).
3. To activate the DMX function, press <MENU> repeatedly until Addr is displayed. Select the start
address from 1 to 512 with <UP> or <DOWN>.
Make sure that the starting address of the interconnected smoke machines
A DMX terminator is recommended for installations where the DMX cable has to run a long distance or is
in an electrically noisy environment (e.g. discos). The terminator prevents corruption of the digital
control signal by electrical noise. The DMX terminator is simply an XLR plug with a 120 Ω resistor
between pins 2 and 3, which is then plugged into the XLR output socket of the last device in the chain.
When the smoke machine is connected to a DMX controller, this controller
will take priority to the on-board control panel of the haze machine.
Remove the DMX cable before using the on-board control panel.
Activating/Deactivating the Fluid Sensor
To protect the pump, the smoke machine uses an infrared fluid sensor to test if there is smoke fluid in
the fluid tank. If the sensor does not detect any fluid, the smoke machine will enter the protection mode
and shuts the pump down. The display will start flashing.
To reactivate the pump after shut-down:
1. Via the DMX mode, set the output to 0 (zero). Then, set it to working status again to get smoke
fluid into the feeding tube. If the smoke machine re-enters the protection mode, please repeat this
procedure.
2. Using the remote control, shortly press the output button and release. Then, hold the button
pressed for approximately 10 seconds or until you hear the fluid flow into the feeding tube.
V. 01 – 06/01/2016
HQSM10005
do not overlap.
8 ©Velleman nv