Searching From The Bluetooth Device - Sony XNV-770BT Mode D'emploi

The Bluetooth setting menu appears.
Back ATT
BT Menu
Signal
Discoverable
Device Name
Search
Device List
3
Touch "Search."
A search for connectable Bluetooth devices
starts.* 1 * 2
After the search is complete, the list of
detected devices*
*1 If the Bluetooth signal of this unit is off, it
activates automatically when searching starts.
*2 Search time varies depending on the number of
connectable devices.
*3 The name or address (if name is unavailable) of
detected devices is displayed.
4
Touch the device to connect.
5
Select the connection type.
Touch "Handsfree Connect" to use for
handsfree calling.
Touch "Audio Connect" to use for audio
streaming.
Pairing starts and the passkey input display
appear.
6
Touch the number keys to enter the
passkey, then touch "OK."
Also perform the required operation on the
other Bluetooth device.
Pairing is complete and this unit is connected
to the other Bluetooth device.
When connection is made successfully,
appears at the bottom of the display.
Searching from the Bluetooth
device
The procedure to search for this unit from the
other Bluetooth device is explained below.
1
Select the Bluetooth source.
To select Bluetooth Phone, press (TOP), then
touch "BT Phone" in the top menu.
To select Bluetooth Audio, touch "Source
List," then "BT Audio."
2
Touch "BT Menu."
In the case of Bluetooth Audio, touch "Play
Menu," then "BT Menu."
The Bluetooth setting menu appears.
3
Touch "Signal," then "Yes" to set
"Signal" to "ON."
The Bluetooth signal of this unit is activated.
38
Top
OFF / ON
Hide / Show
1/2
3 appears.
4
Touch "Discoverable" to set to
"Show."
This unit is ready to be detected by the other
Bluetooth device.
5
Start searching for this unit from the
other Bluetooth device.
After the search is complete, this unit appears
as "Sony Automotive"* in the list of the other
Bluetooth device.
* Can be changed in the Bluetooth setting
(page 46).
After you perform the required operation on
the other Bluetooth device, the passkey input
display appears on this unit.
6
Touch the number keys to enter the
passkey, then "OK."
Pairing is complete and this unit is connected
to the other Bluetooth device.
When connection is made successfully,
appears at the bottom of the display.
Notes
• While connecting to a Bluetooth device, this unit
cannot be detected from another device. To enable
detection, disconnect the current connection.
• Depending on the device, searching from this unit
may not be possible. In this case, search for this unit
from the other device.
• If you search from this unit and another device at the
same time, this unit will not recognize the other
device.
• It may take time to search or connect.
or
• Depending on the device, the connection
confirmation display may appear before inputting the
passkey.
• The time limit for inputting the passkey differs
depending on the device.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).
DR-BT30Q
Sony
Automotive
XXXXXXX
or