Télécharger Imprimer la page

Makita LS1018 Manuel D'instruction page 9

Masquer les pouces Voir aussi pour LS1018:

Publicité

Les langues disponibles

Les langues disponibles

switch trigger is released, have the tool serviced at a
Makita service center.
CAUTION:
The blade brake system is not a substitute for
the blade guard. Never use tool without a
functioning blade guard. An unguarded blade
may result in serious personal injury.
Electronic function
Soft start feature
This function allows the smooth start-up of the tool
by limiting the start-up torque.
Laser beam action
For model LS1018L only
NOTE:
Before the first use, install the dry cells provided
separately from the tool in the cell box. Refer to the
section titled "Replacing the dry cells for laser unit"
for the installment.
CAUTION:
When not in use, be sure to turn off the laser
1
010257
CAUTION:
LASER RADIATION
Do not stare into beam.
Before shifting the laser line or performing
maintenance adjustment, be sure to unplug the
tool.
To turn on the laser beam, press the upper position (I) of
the switch. To turn off the laser beam, press the lower
position (0) of the switch.
Laser line can be shifted to either the left or right side of
the saw blade by loosening the screw holding the laser
unit box and shifting it in the desired direction. After
shifting, be sure to tighten the screw.
1. Switch for laser
9
1. Screw holding the laser unit box
010473
Laser line is factory adjusted so that it is positioned within
1 mm (0.04") from the side surface of the blade (cutting
position).
NOTE:
When laser line appears dim and hard to see
because of direct sunlight, relocate the work area to
a place where there is less direct sunlight.
Replacing the dry cells for laser unit
010399
1
010259
Remove the lid for the dry cells for laser unit by sliding
while pressing it. Take out the old dry cells and put the
new ones as shown in the figure. After replacing, return
the lid to cover it.
Cleaning of the lens for the laser light
If the lens for the laser light becomes dirty, or sawdust
adheres to it in such a way that the laser line is no longer
easily visible, unplug the saw and remove and clean the
lens for the laser light carefully with a damp, soft cloth.
1
1. Dry cell

Publicité

loading

Ce manuel est également adapté pour:

Ls1018l