Rinse Aid - Bosch SHS863WD2N Notice D'utilisation

en-us Rinse Aid
,

Rinse Aid

To achieve proper drying, always use
R i n s e A i d
a liquid rinse aid, even if your
detergent contains a rinse aid or
drying additive.
The dishwasher indicates low
Note:
rinse aid by turning on the Rinse Aid
indicator on the display 8. If this
indicator lights up, you need to refill
the rinse aid dispenser 9* by
following the directions below.
Adding rinse aid
NOTICE
To avoid oversudsing or clogging, do
not overfill the rinse aid
dispenser 9*. Wipe up any spills
with a damp cloth.
Open the rinse aid dispenser 9*
1.
by pressing on the latch of the lid
and pull it open.
12
Add liquid rinse aid to the
2.
dispenser 9* until it is full. Do
not overfill.
Close the lid. Lid must be fully
3.
closed until it clicks in order to
seal.
Wipe up any excess rinse aid that
4.
may have puddled when the
dispenser reservoir is full.
The indicator light will go out a few
moments after the dishwasher door
is shut.
NOTICE
Do not fill the rinse aid dispenser 9*
with detergent. Doing so will damage
the dishwasher.
Setting the amount of rinse
aid used
The amount of rinse aid dispensed
can be set from §:‹‹ to §:‹‡. The
factory setting is §:‹†.
You should only change the setting if
streaks remain on the dishes (lower
the amount), or if dishes are not
getting dry enough (increase the
amount).
Setting Amount
dispenser is OFF
§:‹‹
lowest setting
§:‹‚
low setting
§:‹ƒ