Bosch SHP87PW55N Notice D'utilisation page 33

Cancel a cycle (Reset)
Open the door and press and
1.
hold Start button P for
approximately 3 seconds until the
display reads ‹:‹‚, then close
door again.
Wait about 1 minute while the
2.
dishwasher drains.
Open the door and press the
3.
On/Off button (.
Changing the wash cycle
When the Start button ( has been
pressed, the wash cycle cannot be
changed. The only way a wash cycle
can be changed is by terminating the
wash cycle (Reset).
Intensive drying
The final rinse uses a higher
temperature which improves the
drying result. The cycle time may
increase slightly. (Caution if utensils
are delicate!)
This feature has two settings:
š:‹‹ Off
š:‹‚ On
Open the door.
1.
Press the On/Off button (.
2.
Hold down function key # and
3.
press Start button P until the
display 8 indicates š:x (x can
be any number).
Release both buttons.
4.
Press function key # until the
5.
display 8 indicates the factory
set value š:‹‹.
Press function key 3 to switch
6.
the Extra dry feature on š:‹‚ or
off š:‹‹.
Press Start button P to save
7.
setting.
Operating the Dishwasher en-us
TimeLight
®
(Optical display while the
wash cycle is running)
While wash cycle is running, an
optical display (additional cycle
information) is indicated on the floor
under the appliance door. If the base
panel is pulled forwards or if the
appliance is installed at eye-level with
flush furniture front, the display is not
visible.
This feature has three settings:
†:‹‹ Optical display is switched
off.
†:‹‚ Time remaining and cycle
progress is displayed
alternating with the Bosch
logo (about 5 seconds per
image).
†:‹ƒ Like †:‹‚. Additional wash
cycle options are displayed.
All time remaining displays
! Bosch logo
®
Pre-rinse
Cleaning
Rinsing
Drying
®
33