Télécharger Imprimer la page

Makita PC1100 Manuel D'instruction page 6

Publicité

Les langues disponibles

Les langues disponibles

NOTE:
The ordinary diamond wheels on the market have
no exhaust holes, so dust evacuation is poor. Also,
if the installing hole is not of the exact diameter,
tool vibration occurs and accidents can occur.
ALWAYS USE A MAKITA OFFSET DIAMOND
WHEEL.
Dust bag
004767
To install dust bag, press bag fitting to inside, open
mouth of bag and slip onto dust port.
Remove dust bag when it begins to touch cutting surface.
This is a sign that it is full. Failure to empty bag will lead
to poor suction/pickup.
OPERATION
Planing in corners
004768
Flush planing of corners is possible after first removing
the dust cover.
Turn dust cover clockwise until it stops, light toward you
to remove.
1
004769
1. Dust bag
1
2. Fitting
2
1. Dust cover
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
2
004770
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These
accessories
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
persons.
attachment for its stated purpose.
6
1. Limit mark
1
1. Brush holder
cap
2. Screwdriver
or
attachments
Only use
accessory or
are

Publicité

loading