Wall Mounting - Videotec MAXIMUS MMX Manuel D'instructions

6.5.2 Wall mounting

The product can be installed on a wall.
Fasten the fastening support (01) to its final
installation surface.
Tighten the screws.
Attach the housing support (03) to the fastening
support (01) using the M8 screw (05), washers and
nut. Once the final position of the product is defined,
fully tighten the M8 screw (05) and fasten the M5
screws (08) to block rotation.
The cable connected to the housing could hinder
operations You can, by dismantling the sunshield,
rotate the housing 180° (8.5 Sunshield mounting,
page 23).
Fig. 9
Housing in normal position.
MNVCMMX_1821_EN
08
01
08
05
03
Fig. 10
Housing in overturned position.
Fig. 11 Rear view of completed installation.
Pay attention to the fixing. Tightening
torque: M5 screws, 9Nm (±0.5Nm). M8
screw, 16.5Nm (±0.5Nm).
08
01
08
05
03
15