Fixing To Parapet Or Ceiling Mount - Videotec MAXIMUS MMX Manuel D'instructions

6.5.1 Fixing to parapet or ceiling mount

The product can be installed on a parapet or on the
ceiling.
Fasten the fastening support (01) to its final
installation surface.
Tighten the screws.
Attach the reinforcement support (02) to the housing
support (03) using the M5 screws and the 5 washers
supplied. Fasten the 2 supports assembled as such to
the fastening support (01) using the M8 screw (05),
the 8 toothed washers and a relevant spacer (04).
Once the final position of the product is defined, fully
tighten the M8 screw (05) and fasten the M5 screw
(08) to block rotation.
The cable connected to the housing could hinder
operations You can, by dismantling the sunshield,
rotate the housing 180° (8.5 Sunshield mounting,
page 23).
01
04
Fig. 4
Ceiling mounting (housing in normal position).
01
04
Fig. 5
Ceiling mounting (housing in overturned position).
14
Fig. 6
Fastening to a parapet or to the ceiling depends on
the position of the fastening support.
08
Fig. 7
02
03
05
08
Fig. 8
02
03
05
Rear view of completed installation.
Parapet mounting.
Ceiling mounting.
Pay attention to the fixing. Tightening
torque: M5 screws, 9Nm (±0.5Nm). M8
screw, 16.5Nm (±0.5Nm).
MNVCMMX_1821_EN