Num'axes CANICOM 800 Expert Guide D'utilisation page 24

 Activate/deactivate the collar with the remote control
A magnet located in the remote control is used to either switch on/off the receiver collar.
- Activate: move the remote control towards the collar so that the magnet position indicator on the remote
control comes into contact with the red mark on the collar, hold for 1 second (ref. Diagram 7 or Diagram
8). The green indicator light on the collar will flash indicating that the collar is On.
- Deactivate : move the remote control towards the collar so that the magnet position indicator on the
remote control comes into contact with the red mark located on the receiver, hold for 1 second (ref. Diagram 7
or Diagram 8). The green indicator light on the collar flashes quickly then goes out indicating the collar
is Off.
If you have several collars, renew the same procedure for each one.
To increase the battery life of the receiver collar, we recommend you deactivate the unit if you are not
using it for a long period.
Diagram 7
Activate/Deactivate a collar
with a CANICOM 800 Expert
remote control
Place these 2 areas together
for 1 second
Gb - 24
Activate/deactivate the receiver collar
Activate/Deactivate a collar
with a CANICOM 1200 Expert
remote control
Place these 2 areas together
for 1 second
Diagram 6
with the magnetic key
Diagram 8