Menu; Navigating Through The Menu - NEFF C1 KS61N0 Série Mode D'emploi

Menu

The menu is used for changing individual
settings, accessing information and launch-
ing processes.
■ Touch A to open the menu.
The different setting options will appear.

Navigating through the menu:

The various menu points, e.g. "Language"
can be selected with the K or L button.
The respective setting, e.g. "Deutsch" are
displayed with M and changed with K
or L. Press N to exit the respective
setting again.
Language
Set the language you require
For example:
Set the appliance at 15 minutes to switch
off automatically:
■ Touch A. The menu opens.
■ Select "Switch off after" with the K or
L arrow button.
■ Press the M arrow button.
■ Select "0h 15min" with the K or L
arrow button.
■ Touch A. "Save changes?" appears.
■ Press the M arrow button. The setting
is saved.
The drink selection appears on the display.
F
Press A to exit the menu at any
time. If no entry is made within
approx. 30 seconds, the menu
closes automatically and the settings
are not saved.
The following settings can be made:
Language
Set the desired language to show the
display texts.
Water hardness
Set this to the local water hardness.
English
Level "1 (soft)" to "4 (very hard)" can be
selected. The preset water hardness is
"4 (very hard)".
F
It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run.
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier. If a water softening
system is installed in the house, please
select the "Softening device" setting.
Water filter
If a water filter is inserted, renewed or
removed, the setting "Activate", "Replace" or
"Remove" must be made in the menu.
F
A water filter lessens limescale
deposits and reduces impurities in
the water. The appliance also does
not need to be descaled so often.
Water filters are available from retail
outlets or from customer service (see
section "Accessories").
Inserting or renewing a water filter:
A new water filter must be rinsed before it
can be used.
■ Select either "Activate" or "Replace" with
the K or L arrow button.
■ Press the water filter firmly into the
opening of the water tank.
■ Fill the water tank with water up to the
"max" mark.
■ Remove the milk tube from the milk
container and close the door.
F
Caution: Do not jam the tube when
closing the door.
■ Place a container with a capacity of
0.5 litre under the outlet.
Menu en
49