Skil PWRCORE 12 RI574501 Guide D'utilisation page 12

Direction-of-Rotation (Forward/Center-Lock/Reverse) Selector
WARNING
Your tool is equipped with a direction-of-rotation selector located above the trigger switch.
This selector is designed for changing the direction of rotation of the bit and for locking the
trigger in the "OFF" (center-lock) position.
a. Position the direction-of-rotation selector to the far left of the tool for forward rotation.
b. Position the direction-of-rotation selector to the far right of the tool for reverse rotation.
c. Set the switch in "OFF" (center-lock) position to help reduce the possibility of accidental
starting when not in use. (Fig. 3)
NOTICE: To prevent gear damage, always allow the tool to come to a complete stop before
changing the direction of rotation.
NOTICE: The tool will not run unless the direction-of-rotation selector is engaged fully to the
left or right.
Fig. 3
Forward
Variable-Speed Trigger Switch
Your tool is equipped with a variable-speed
trigger switch. The tool can be turned "ON" or
"OFF" by depressing or releasing the trigger,
respectively.
The variable-speed trigger switch delivers
higher speed with increased trigger pressure
and lower speed with decreased trigger
pressure (Fig. 4).
12
After tool use, lock the direction-of-rotation selector in the "OFF"
position (center-lock) to help prevent accidental starts and injury.
Center-Lock
Fig. 4
Variable-Speed
Trigger Switch
Reverse