Ryobi RMT300 Traduction Des Instructions Originales page 5

WARNING
When servicing, use only original manufacturer's
replacement parts. Use of any other parts may create a
hazard or cause product damage.
If the power supply cord is damaged, it must be replaced
only by the manufacturer or by an authorised service centre
to avoid a safety hazard. Contact authorised service centre.
WARNING
For greater safety and reliability, all repairs should be
performed by an authorised RYOBI service centre.
GENERAL
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents and may be damaged by their use. Use clean
cloths to remove dirt, carbon dust, etc.
WARNING
Do not, at any time, let brake fl uids, gasoline, petroleum-
based products, and penetrating oils, come in contact
with plastic parts. They contain chemicals that can
damage, weaken, or destroy plastic.
The dust from plaster and wall board is abrasive and may
cause premature failure of the product if it is allowed to
enter the motor area. Always use the dust extraction
accessory connected to a vacuum. Thoroughly clean the
product after use by using a brush and a vacuum. Take
care not to push dirt into the ventilation openings. Beware
of using compressed air to clean the product because dust
and grit can cause serious eye injury.
LUBRICATION
All of the bearings in the product are lubricated with a
suffi cient amount of high grade lubricant for the life span of
the product under normal operating conditions. Therefore,
no further lubrication is required.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
of as waste. The machine, accessories, and
packaging should be sorted for environment-
friendly recycling.
SYMBOLS ON THE PRODUCT
Safety Alert
V Volts
Hz Hertz
Alternating current
W Watts
n No-load speed
o
min‫¹־‬ Revolutions or reciprocations per minute
CE Conformity
EurAsian Conformity Mark
Ukrainian mark of conformity
Class II tool
Double insulation
Wood – Plunge and fl ush cuts
Non-ferrous metal – Plunge and fl ush cuts
Plastic – Plunge and fl ush cuts
Drywall – Plunge and fl ush cuts
Concrete – Tile grout removal
Tile adhesive removal
Please read the instructions carefully before
starting the product.
Wear eye, hearing and respiratory protection.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
SYMBOLS IN THIS MANUAL
Note
Connect to the power supply.
Disconnect from the power supply.
Parts or accessories sold separately
EN
FR
DE
ES
IT
NL
PT
DA
SV
FI
NO
RU
PL
CS
HU
RO
LV
LT
ET
HR
SL
SK
BG
UK
TR
EL
English | 3