Kenwood DNX9990HD Mode D'emploi page 7

2
Touch [Finish].
NOTE
For details on operations of each setting,
refer to the Instruction Manual.
How to prepare the remote
controller
Insert two "AAA"/"R03"-size batteries
with the and
properly, following the illustration
inside the case.
CAUTION
Put the remote controller in a place where
it will not move during braking or other
operations. A dangerous situation could
result, if the remote controller falls down
and gets wedged under the pedals while
driving.
Do not leave the battery near fire or
under direct sunlight. A fire, explosion or
excessive heat generation may result.
Do not recharge, short, break up or
heat the battery or place it in an open
fire. Such actions may cause the battery
to leak fluid. If spilled fluid comes in
contact with your eyes or on clothing,
immediately rinse with water and consult
a physician.
Place the battery out of reach of children.
In the unlikely event that a child swallows
the battery, immediately consult a
physician.
7
EN
DNX9990HD
poles aligned