Publicité
Les langues disponibles
Les langues disponibles
3-6. Abbreviation Meaning in LCD Display
Abbreviation
Display content
ENA
DIS
ATO
BAT
NCF
CF
SUB
ADD
ON
OFF
FBD
OPN
RES
N.L
CHE
OP.V
PAR
3-7. LCD Setting
There are three parameters to set up the UPS. Refer to following diagram.
Parameter 1
Parameter 2
Note: The following order of setting code only presents when UPS is in Bypass Mode or no-output mode. The setting
code number will change the numbers under other modes. For example, when the UPS is in AC mode, the total
available setting becomes 7 only. Then, setting code of "Bypass mode setting" will become 01, "Battery backup time
setting" will become 02, and so on.
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 04 14 AA 59 203 37
Parameter 3
Meaning
Enable
Disable
Auto
Battery
Normal mode (not CVCF mode)
CVCF mode
Subtract
Add
On
Off
Not allowed
Allow
Reserved
Neutral line loss
Check
Output voltage
Parallel, 001 means the first UPS
Parameter 1: It's for program alternatives. Refer
to below table.
Parameter 2 and parameter 3 are the setting
options or values for each program.
62
Publicité
Chapitres
Dépannage
