Safety And Emc Instructions; Important; Transportation And Storage; Preparation - INFOSEC E6 LCD 10K TM RM Manuel Utilisateur

1. Safety and EMC instructions

Please strictly comply with all operating instructions in this manual strictly. Keep this
manual in a safe place and read the following instructions carefully before installing the
unit. Do not operate this unit before carefully reading all warnings and operating
instructions.

IMPORTANT!

Installing and connecting UPSs in a way that does not comply with accepted practices releases Infosec
Communication from any liability.

1-1. Transportation and Storage

Please only use the original packaging when transporting the UPS system to protect against shock and

impact.
The UPS must be stored in a room that is ventilated and dry.


1-2. Preparation

Condensation may occur if the UPS system is moved directly from a cold to warm environment. The UPS

system must be absolutely dry before being installed. Please allow at least two hours for the UPS system to
acclimatize to the environment.
Do not install the UPS system near water or in damp environments.

Do not install the UPS system where it would be exposed to direct sunlight or near a heater.

Do not block air ventilation holes in the UPS housing. The UPS must be installed in a
location with good ventilation or with air-conditioning. Ensure enough space on each side
for ventilation. Ideally, the room temperature doesn't exceed 20°C and 0-90%
non-condensing humidity.

1-3. Installation

Do not connect appliances or devices which would overload the UPS (e.g. large motor-type equipment) to

its output sockets or terminal.
Do not connect domestic appliances such as hair dryers to UPS outlets.

Place cables in such a way that no one can step on or trip over them.

The UPS provides a grounded terminal, in the final installed system configuration and equipotential ground

bonding to the external UPS battery cabinets.
The UPS may only be installed by qualified maintenance personnel.

An appropriate disconnection device for short-circuit backup protection should be provided in the building

wiring installation.
An integral single emergency switching device to prevent further supply to the load by the UPS regardless

of the mode of operation should be provided in the building wiring installation.
Connect the ground before connecting to the building wiring terminal.

Installation and wiring must be performed in accordance with local electrical laws and regulations.

INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
43
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 04 14 AA 59 203 37