Starting The Driver Control Program; Configuring The Communications Port - Sanyo CE42LM5WP Manuel D'utilisation

STARTING THE DRIVER CONTROL PROGRAM

Connect the touchscreen cable to a free serial port of the.
1. If the Touchscreen control panel is not already running, start the driver by clicking the icon on
the desktop or select the Windows™
necessary path or double click Ma7_Control_En.exe
short cut placed on the desktop.
When the program is started it displays the following window (Fig 1):

CONFIGURING THE COMMUNICATIONS PORT

When the program has loaded:
1. Select the Comms tab.
2. Select the comm port the Touchscreen is connected to.
3. Make sure the driver box called
touchscreen is connected to.
4. Select a Baud rate of 19,200.
5. Tick the 'Open' box in the
6. When the driver recognizes the screen, the Open,
7.
The button called Reset
START button and
Fig 1
'Present' is red and select the appropriate port that the
Status section.
will reset the touchscreen driver when pressed.
7
RUN "Ma7_Control_En.exe"
from 'Windows Explorer™' or click the
Active and Valid boxes will go red (fig 2).
with the