Electrolux ENS6TE19S Notice D'utilisation page 18

18 www.electrolux.com
8.1 What to do if...
Problem
The appliance does not
operate.
The appliance is noisy.
Acoustic or visual alarm is
on.
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "FastFreeze"
or "FastCool", or after
changing the temperature.
Possible cause
The appliance is switched
off.
The mains plug is not con‐
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup‐
ported properly.
The cabinet has been re‐
cently switched on.
The temperature in the ap‐
pliance is too high.
The door is left open.
Temperature is set incor‐
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastFreeze function is
switched on.
The FastCool function is
switched on.
The compressor starts af‐
ter a period of time.
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri‐
cal appliance to the mains
socket. Contact a qualified
electrician.
Check if the appliance
stands stable.
Refer to "Door Open
Alarm" or "High Tempera‐
ture Alarm".
Refer to "Door Open
Alarm" or "High Tempera‐
ture Alarm".
Close the door.
Refer to "Control Panel"
chapter.
Wait a few hours and then
check the temperature
again.
Refer to "Installation" chap‐
ter.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door"
section.
Refer to "FastFreeze func‐
tion" section.
Refer to "FastCool func‐
tion" section.
This is normal, no error
has occurred.