Switching The Appliance On; Preparing The Door Panels; Loading The Appliance Door; Removing The Positioning Aid - Bosch B36IT800NP Notice De Montage

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.

Switching the appliance ON

To guarantee the accuracy of the following working steps
and thus the appearance of the overall kitchen front later
on, the appliance should now be operated.
1.
Open the appliance door.
2.
Press the POWER button.
3.
Press the POWER button again to shut off.
Only for appliances with a water connection:
In order to avoid the risk of damage caused by leaking
water from damage possibly caused to the water pipe
feeding the appliance, keep the shut-off valve closed.
4.

Preparing the door panels

Important note:
When performing any work on the door panels, always
observe the following:
Always screw into the best load-bearing material of
the door panel.
Never screw into fillers, decorative strips or similar.
Select a screw length which is always shorter than
the thickness of the door panel.
To prevent damage, protect surfaces of the door
panels during installation.
The total weight of the door panel must not exceed the
following values:
BottomFreezer 36"
(top, 2 door)
BottomFreezer 36"
(bottom)
In the case of 30" and 36" wide appliances 2 adjacent
door panels can be attached instead of one large door.
These door panels must be connected to a metal strip
on the rear.
This metal strip can be purchased from customer service
as an optional accessory, see the section on "Required
accessories and tools/Optional accessories".
Note:
The instructions for carrying out this work step can be
found in the separate installation instructions for this
accessory.
2 x 28.6 Ibs/2 x 13 kg
28.6 Ibs/13 kg
5.

Loading the appliance door

When attaching the door panels, it is recommended to
load the door storage compartments in the appliance
with weights in order to ensure that the gap width is as
precise as possible.
Recommendations:
BottomFreezer 36"
(top, 2 door)
BottomFreezer 36"
(bottom)
6.

Removing the positioning aid

Unscrew the positioning aid from the appliance door.
Note:
Store the positioning aids, there will be used in an
installation step later.
2 x 27 Ibs/2 x 12 kg
22 Ibs/10 kg
19

Publicité

Table des Matières
loading

Table des Matières