EINHELL TC-AC 190/8 Kit Mode D'emploi D'origine page 18

be no dust, acids, vapors, explosive gases or
inflammable gases in the room.
•
The compressor is designed to be used in dry
rooms. It is prohibited to use the compressor
in areas where work is conducted with spray-
ed water.
•
Operate the equipment only on a firm, level
surface.
•
During operation place the compressor on the
rubber feet on the compressor rear wheel.
•
Important! When you switch off the com-
pressor, excess air will escape at the safety
valve. This is not a fault, but arises in connec-
tion with the equipment's construction.
6. Assembly and starting
6.1. Power supply
Before you use the machine, make sure that the
mains voltage complies with the specifi cations on
the rating plate. Long supply cables, extensions,
cable reels etc. cause a drop in voltage and can
impede motor start-up. At low temperatures below
+5°C, sluggishness may make starting diffi cult or
impossible.
6.2 On/Off switch (4)
To switch on the equipment set the On/Off switch
(4) to position 1.
Move the On/Off switch (4) to position 0 to switch
off the equipment.
6.3 Compressed air hose with quick-lock
coupling (3)
Connecting:
Insert the nipple of the air tool into the quick-lock
coupling, the sleeve will spring forward automa-
tically.
Disconnecting:
Pull back the sleeve and remove the tool.
Danger! When releasing the quick-lock cou-
pling, be sure to hold the coupling piece to
protect yourself against injury from the re-
bounding hose.
Anl_TC_AC_190_8_Kit_SPK1.indb 18 Anl_TC_AC_190_8_Kit_SPK1.indb 18
GB
6.4 Tire pressure gauge with adapters
(Fig. 2)
Working pressure in bar: 0-10
Range of applications:
You can use the tyre pressure gauge to infl ate ty-
res. Adapters are included for other valve types.
Use the pressure gauge to check the tyre pressu-
re. Press the „ + „ pushbutton to increase the tyre
pressure or the „ - „ pushbutton to decrease the
tyre pressure.
Do not exceed the maximum operating pressure
of 10 bar (also indicated on the back of the tyre
gauge).
Hazard! After infl ating, please check the set tyre
pressure with a calibrated gauge, for example at a
petrol station.
Hazard! Never direct the fl ow of compressed air
at yourself or at any other persons or animals!
Caution! Infl ating items above the recommended
pressure can damage the items or cause injury to
persons nearby!
After fi lling with air, please check the set tire
pressure with a calibrated gauge, for example at a
petrol station.
The tire pressure gauge comes with a valve ad-
apter for car tire valves. Other valve types can be
fi lled using the supplied adapters (a - c).
7. Cleaning, maintenance and
ordering of spare parts
Danger!
Pull the power plug before doing any
cleaning and maintenance work on the ap-
pliance.
Danger!
Wait until the compressor has completely
cooled down. Risk of burns!
Danger!
After use, always switch off the equipment
immediately and pull out the power plug.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
- 18 -
17.10.2016 14:26:10 17.10.2016 14:26:10