Before You Start - Initial Set Up - Krushr F86/024 Guide De L'utilisateur

US/Can

Before you Start - Initial Set Up

Install your appliance and ensure either a stainless steel door or furniture door is
fitted in accordance with the instructions contained in the Installation Manual.
Ensure the door is closed before turning the power on. Once the power is on you
will hear a bleeping noise indicating that the appliance is setting itself for use.
Ensure all packaging and literature has been removed from the appliance and that
the bottom plate inside the Main Collection Bin is inserted smooth side facing
inside the bin.
Please Note: As a safety precaution all drawers inside the appliance and the main
door must be fully closed for the appliance to operate. A rapid bleeping alarm will
sound if a drawer or door is open. Close the open drawer or door to stop the
alarm.
POWER CUT
In the event of a power cut the appliance will automatically reset itself by
returning the crushing mechanisms to their neutral position provided that all
drawers and main door are fully closed.
DO NOT OPERATE
Do not operate the appliance without a main door fitted.
DUTY CYCLE
The design of this appliance envisages that its compaction mechanisms will not
need to be subject to continuous operation and the motors used have been
specified accordingly. Each compaction mechanism should not be subject to more
than two minutes continuous use (approximately 6 cycles of either the Can Crush
Drawer or compaction of the Main Collection Bin). In the event of continuous
operation for two minutes, the relevant mechanisms should not be used for 18
minutes before further operation. Failure to comply with this requirement will
cause the relevant motor to exceed its "duty cycle" and will void your warranty.
10