Operation Instructions - Danby DAC060BEUWDB Guide D'utilisation

OPERATING INSTRUCTIONS
KEY PAD FEATURES
Set Mode Mode Follow Me Displays Temperature, Adjust Temperature
Button Indicator Indicator Time or Error Code Or Time
Fan Speed
Remote Signal
Indicator
Receptor
Fan Speed
Power Button
Button
Ionizer Button
Energy Saver Check Filter / Sleep Mode Auto-Timer
Mode Button Reset Filter Button Button
Button
POWER: Turns unit On/Off. NOTE: The unit will automatically launch the Energy Saver function when it is in Cool, Dry and
Auto modes.
IONIZER: The ionizer function will cause the air fi lter inside the unit to be negatively charged. Dust particles in the air are
naturally positively charged and will be drawn to the negatively charged air fi lter, ensuring your home remains as dust free as
possible.
ENERGY SAVER: Automatically cycles the fan on and off while the compressor is not in use. This function is available in Cool,
Dry, and Auto modes (only Auto-Cool and Auto-Fan modes). The fan will continue to run for 3 minutes after the compressor
shuts off. The fan then cycles on for 2 minutes at 10 minute intervals,until the room temperature is above the set temperature.
At this point, the compressor turns back on and cooling restarts.
CHECK FILTER / RESET FILTER: The adjacent indicator light will illuminate as a reminder to clean the air conditioner fi lter
(see page 12). Once the fi lter has been cleaned and replaced, depress the Check Filter button in order to resume operation.
SLEEP MODE: In this mode, the selected temperature will increase (when in cooling mode) by 1°C / 2°F one half-hour after
Sleep mode has been selected. The temperature will then increase by another 1°C / 2°F after an additional half hour. This new
temperature will be maintained for 6 hours before returning to the originally selected temperature. This ends the Sleep mode
and the unit will continue to operate as originally programmed. The Sleep mode program can be cancelled at any time during
operation by pressing the Sleep button again.
AUTO-TIMER: Used to initiate the Auto On/ Auto Off timer.
When the air conditioner is off (Auto-On feature):
1) Press the Auto-Timer button once and the adjacent Auto-On indicator light will illuminate.
2) Use the Temp/Timer control cursors to select a delayed ON time of up to 24 hours.
3) Select the appropriate mode under which you want the unit to operate (Auto-Cool-Dry-Fan Only).
4) Select the fan speed setting.
5) The time you selected will appear in the LED display.
When the air conditioner is on (Auto-Off feature):
1) Press the Auto-Timer button twice and the adjacent Auto-Off indicator light will illuminate.
2) Use the Temp/Timer control cursors to select a delayed OFF time of up to 24 hours.
3) The time you selected will appear in the LED display. The Auto-On and Auto-Off timer features can operate during the same
program by defi ning the Auto-Off parameters immediately after the Auto-On parameters.The Auto-Timer may be cancelled at
any time by turning the unit On/Off.
For example, if you want to turn the unit on one hour later, to operate for one hour and then stop, set Auto-On "1" and Auto-Off
"2".
Note: This is a "one-shot" timer. It does not continue to cycle on and off. It will turn the unit on (if set by the user) ONE time.
It will turn the unit off (if set by the user) ONE time. If you require the unit to turn on/off again automatically, then you must set
the timer again.
8