Danby DAC060BEUWDB Guide D'utilisation page 11

OPERATING INSTRUCTIONS
KEY PAD FEATURES CONTINUED
Set Mode Mode Follow Me Displays Temperature, Adjust Temperature
Button Indicator Indicator Time or Error Code Or Time
Fan Speed
Remote Signal
Indicator
Receptor
Fan Speed
Power Button
Button
Ionizer Button
Energy Saver Check Filter / Sleep Mode Auto-Timer
Mode Button Reset Filter Button Button
Button
FAN SPEED: Select from four different fan settings: Low, Medium, High and Auto during Cool and Fan Only mode. Please
note, during Dry mode the fan speed is automatically defi ned.
TEMP / TIMER CONTROL: Used to increase or decrease the Temperature setting in 1°C / 1°F increments, and Auto-
Timer On/Off settings in 30min./1hr. increments. Note: This appliance allows you to select the temperature scale to be dis-
played in either "Celsius" or "Fahrenheit" according to your preference.To change the temperature scale displayed on the
electronic display, press both the "Temp/Timer" adjust arrows simultaneously to alternate between Celsius and Fahrenheit.
LED DISPLAY: Displays the following information independently - Set Temperature, Ambient RoomTemperature, Auto
Timer On/Off settings and error codes.
FOLLOW ME: There is a temperature sensor built into the remote control that will continuously collect the current room
temperature. Keep the remote control with you as you move throughout your home and the unit will automatically adjust
the set temperature based on the current temperature where you are located to reach the most comfortable condition and
temperature.
To activate the FOLLOW ME feature, point the remote control at the unit and press the FOLLOW ME button. The remote
will display the current temperature at its location. The remote will send a signal to the air conditioner every 3 minutes,
so long as you remain within range of the unit. The FOLLOW ME light on the control panel of the unit will illuminate for 5
seconds every three minutes to indicate that it has received a signal from the remote. If the unit does not receive a signal
from the remote during any 7 minute interval, the unit will beep to indicate that the FOLLOW ME mode has ended.
To disable the FOLLOW ME feature when it is active, point the remote at the unit and press the FOLLOW ME button.
The maximum distance for the FOLLOW ME feature is 8 meters. This feature is available in Cool and Auto modes.
MODE: Allows you to scroll through and select the desired operating mode: Cool, Dry, Fan Only and *Auto. The selected
mode will be denoted by the indicator lights.
*Auto mode is a pre-set factory program that automatically defi nes the mode (Cool or Dry) and fan speed, based on the
set temperature. The unit will automatically launch the Energy Saver function when it is in Cool, Dry, or Auto modes.
9