Overview Of The Components - Clatronic DB 3016 Mode D'emploi & Garantie

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

1 Continuously adjustable

temperature regulator

2 Control lamp

3 Steam jet button

4 Steam volume regulator

5 Spray button

•

Clean the ironing base with a slightly damp cloth.

•

Fill the water reservoir at the reﬁ ll opening (6), using a ﬁ lling container. Close the lid

of the tank so that it locks in place. Preferably use distilled water or clear tap water

(maximum water hardness level 2). If water is harder, used distilled water only.

•

Do not ﬁ ll battery water, water from the clothes dryer and water containing additives

(such as starch, perfume, softener or other chemicals) into the water reservoir. This

could damage the iron due to residues forming in the steam chamber. These residues

may cause impurities to the fabric when dropping out of the holes in the soleplate.

Note: Only clothes should to be ironed with this machine.

•

Remove any protective ﬁ lms and adhesive labels from the stainless steel soleplate

before using the appliance.

•

Completely unwind the line cord.

Ironing without steam (steam jet regulator on 0)

1. Place the iron on its stand.

2. Turn the steam regulator (4) to 0.

3. Electrical connection:

Make sure that the iron voltage (see name plate) and the line voltage match.

4. Always set the temperature control to „0" before connecting the appliance to a power

point, or before disconnecting it.

5. Sort out the garments according to their ironing temperatures. Start with the lower

temperatures. It is set with the thermostat (1):

•

• •

• • •

MAX

05-DB 3016 39